Bambu Filament Cutter Cable and Sensor (for P1P, P1S) also available Some products may have corrosive

Some products may have corrosive and eye irritation substances

When used with the Drywise Inline Filament Dryer

Plug elbow

Wash with plenty of water if you get direct skin contact or eye contact with resins

Substitute build plate for the glass plate in Ultimaker S3 printers

Bambu Filament Cutter Cable and Sensor (for P1P, P1S) also available Some products may have corrosiveDoes this apply? Are you getting these errors on your Bambu printer: HMS_0700_4500_0002_0001 HMS_0700_4500_0002_0003 Is Bambu Studio telling you: The filament cutter sensor is malfunctioning. The sensor may be disconected or damaged. The filament cutter handle has not released. The handle or blade ay be stuck The delicate cable near the PTFE tube is damaged Then this is the part for you. Part number Extru_SW Board Assembly SPC018