Butler Tray Table Hinge 2" Stainless Steel C11058 Arm swings in both directions

Arm swings in both directions so the hinge can be used in either hand

It is made for wood or vinyl gates

The mounting plates measure 2" x 4"

The hinge comes with screws and plastic dowels

Note: Because this item is electronic and improper installation or handling can cause damage to the electronics

Butler Tray Table Hinge 2" Stainless Steel C11058 Arm swings in both directionsThis hinge incorporates a stop which holds the hinge flat in the horizontal position. Mortises flush into surface of table. Folds back a full 180 degrees onto the table. Leaves are 1 16" thick (9 32" at the thickest point). Thickest point measurement is taken with the hinge in its flat position. Also known as a Round Side Hinge. Stamped corrosion resistant 304 Polished Stainless Steel.